Skip to content
Illustrative product concept of a horizontal vacuum furnace with a separate pumping cart

Illustrative product concept; final configuration and specifications are confirmed during engineering review.

Material & process

Share the workpiece alloy, dimensions and target process so the equipment route can be reviewed.

Output & duty

Define batch or throughput needs, operating schedule and required temperature or treatment result.

Site & utilities

Confirm available power, cooling, layout and destination-market requirements before final specification.

Vacuum Furnaces · FL-VHP

Vacuum Hot Press Sintering Furnace with Programmable Load Control

Simultaneous heat and uniaxial pressure to 2,300 °C and 500 kN, producing near-full-density parts from materials that will not densify by sintering alone.

  • Independent temperature and load recipes
  • Densification tracked live through ram displacement
  • Near-theoretical density on materials that resist pressureless sintering
  • Fully automatic cycle including pump-down and controlled cooling
  • Graphite die tooling supplied to your part geometry
Max temperature
2,300 °C
Max pressure
100 – 500 kN, programmable
Working volume
Ø100 × 100 mm to Ø600 × 400 mm
Ultimate vacuum
5 × 10⁻³ Pa
Displacement measurement
±0.01 mm, logged through cycle
Ram
Servo-hydraulic, force or position control
Atmosphere
Vacuum, argon or nitrogen
Operation
Fully automatic from recipe start

Product Details

Hot pressing applies uniaxial load through the graphite die while the part is at sintering temperature. Materials that resist densification by pressureless sintering — boron carbide, silicon carbide, some diamond composites and sputtering target materials — reach near-theoretical density this way.

Load is applied by a servo-hydraulic ram with programmable force and displacement, and the displacement signal is logged so densification can be tracked through the cycle. Temperature and load recipes run independently, so pressure can be applied at the right point in the thermal profile rather than throughout.

The system is fully automatic once the recipe starts: pump-down, ramp, load application, dwell, controlled cooling and vent all run without operator intervention.

FL-VIM

Vacuum Induction Melting Furnace

Melting and casting under vacuum or inert atmosphere from 5 kg to 2 tons, for nickel superalloys, titanium alloys, magnetic alloys and clean specialty steels.

Read More →
Representative induction furnace copper coil manufacturing configuration

Illustrative product concept; final configuration is confirmed during engineering review.

FL-VSF

Vacuum Sintering Furnace

Programmable vacuum and partial-pressure sintering to 2,200 °C with a uniform hot zone, for tungsten carbide, ceramics and PM components.

Read More →
Illustrative product concept of a horizontal vacuum furnace with a separate pumping cart

Illustrative product concept; final configuration is confirmed during engineering review.

FL-GPF

Graphite Purification Furnace

Vacuum high-temperature furnace that purifies graphite powder, electrodes and shaped products by volatilising metallic impurities.

Read More →
Illustrative product concept of a horizontal vacuum furnace with a separate pumping cart

Illustrative product concept; final configuration is confirmed during engineering review.

Tell us what your process needs.

Share the material or part, target output or treatment result, operating schedule and site utilities. Our engineers can review the equipment configuration and quotation scope against your application.