Skip to content
Illustrative product concept of an automated billet induction heating line

Illustrative product concept; final configuration and specifications are confirmed during engineering review.

Material & process

Share the workpiece alloy, dimensions and target process so the equipment route can be reviewed.

Output & duty

Define batch or throughput needs, operating schedule and required temperature or treatment result.

Site & utilities

Confirm available power, cooling, layout and destination-market requirements before final specification.

Induction Heating Systems · FL-IH-PIP

Induction Pipe, Tube and Plate Heating and Annealing Line

In-line heating for pipe coating, bending, normalising and plate hot-forming, with continuous throughput and zone temperature control.

  • Multi-zone control with a pyrometer per zone
  • Line-speed tracking — heating follows conveyor throughput automatically
  • Split coils for maintenance without stripping the line
  • Suitable for 3LPE coating pre-heat, bending, normalising and hot forming
  • Integrates with existing PLC over Profibus, Profinet or Modbus TCP
Pipe diameter
20 – 1,400 mm
Plate width
Up to 2,000 mm
Line speed
0.5 – 30 m / min
Temperature
Up to 1,100 °C
Zones
2 – 8 independently controlled
Power supply
IGBT or KGPS, 100 – 4,000 kW
Coil
Split design for maintenance access

Product Details

Pipe and plate lines heat continuously moving product rather than discrete parts, so the control problem is holding temperature against a varying line speed. Our lines use multi-zone coils with independent power control and a pyrometer at the exit of each zone.

Typical duties are pre-heating pipe before three-layer polyethylene coating, heating for induction bending, post-weld normalising of seam-welded tube, and heating plate before hot forming or levelling.

Coils are split-design so a line stoppage does not require the product to be stripped out, and the line integrates with the existing conveyor's speed signal so heating tracks throughput automatically.

FL-IH-BIL

GTR Billet Induction Heating Furnace

GTR series through-heating line for round and square billets, with pyrometer control, hot and cold reject gates and press synchronisation.

Read More →
Induction billet heating line with steel bars moving through a guarded coil station

Illustrative product concept; final configuration is confirmed during engineering review.

FL-IH-END

Bar End Heating Machine

Heats only the section to be formed — hand tools, axles, anchor bolts and eye bolts — cutting energy per part sharply versus full-length heating.

Read More →
Illustrative product concept of an automated billet induction heating line

Illustrative product concept; final configuration is confirmed during engineering review.

Tell us what your process needs.

Share the material or part, target output or treatment result, operating schedule and site utilities. Our engineers can review the equipment configuration and quotation scope against your application.