Skip to content
Illustrative product concept of a closed-loop furnace cooling skid and hydraulic power unit

Illustrative product concept; final configuration and specifications are confirmed during engineering review.

Material & process

Share the workpiece alloy, dimensions and target process so the equipment route can be reviewed.

Output & duty

Define batch or throughput needs, operating schedule and required temperature or treatment result.

Site & utilities

Confirm available power, cooling, layout and destination-market requirements before final specification.

Auxiliary Equipment & Spares · FL-AUX-COOL

Closed-Circuit Cooling System for Induction Furnaces and Power Supplies

Two-circuit cooling with a plate heat exchanger, deionised internal loop and evaporative or dry cooling tower — the single most important accessory for furnace life.

  • Deionised internal loop — no scale inside the coil
  • Emergency gravity tank protects the coil during a power failure
  • Dry cooler and glycol options for arid or freezing sites
  • Duty and standby pumps with automatic changeover
  • Flow, temperature and conductivity alarms wired to the furnace interlock
Cooling capacity
50 – 3,000 kW heat rejection
Circuits
Two, separated by a plate heat exchanger
Internal water
Deionised, low conductivity
Supply temperature
30 – 35 °C, controlled
Backup
Emergency tank with gravity feed
Tower type
Evaporative, or dry cooler for arid and cold sites
Freeze protection
Glycol loop option for sub-zero sites
Alarms
Flow, temperature, conductivity, pump fault

Product Details

Induction equipment is cooled by water flowing through the copper coil and through the power semiconductors. If that water carries dissolved minerals it deposits scale inside the coil tube, restricting flow until the coil overheats and fails. A closed loop with deionised water eliminates the problem.

The system uses two circuits. The internal circuit carries deionised water through the coil and power supply and never touches the outside world. The external circuit takes the heat away through a plate heat exchanger to a cooling tower. Only the external circuit sees raw water.

Evaporative towers are standard. Dry coolers are supplied where water is scarce or where freezing conditions make an evaporative tower impractical, and a glycol loop is available for sites below 0 °C.

FL-AUX-HYD

Hydraulic Tilting Station

Twin-cylinder hydraulic tilting with proportional speed control, mechanical safety lock and emergency hand pump for controlled pouring at any capacity.

Read More →
Illustrative product concept of a closed-loop furnace cooling skid and hydraulic power unit

Illustrative product concept; final configuration is confirmed during engineering review.

FL-AUX-CAB

Water-Cooled Cables & Capacitors

Flexible water-cooled cables, electrothermal resonant capacitors, thyristor and IGBT modules, fuses and control boards, referenced to your machine serial number.

Read More →
Illustrative product concept of a closed-loop furnace cooling skid and hydraulic power unit

Illustrative product concept; final configuration is confirmed during engineering review.

FL-AUX-REF

Furnace Lining Refractory

Furnace-lining material and installation-tooling options reviewed against furnace design, alloy, slag practice and operating conditions.

Read More →
Illustrative product concept of an induction furnace refractory lining, steel former and ramming materials

Illustrative product concept; final configuration is confirmed during engineering review.

Tell us what your process needs.

Share the material or part, target output or treatment result, operating schedule and site utilities. Our engineers can review the equipment configuration and quotation scope against your application.